Joined in 2023 
82 
63 About this deal
The downside of the Arete One’s hassle-free approach is that you don’t have as much direct control over fan speeds, timers or noise levels that you get with some other dehumidifiers. As far as I’m concerned this isn’t really a problem, as the Smart controls work so well, but if you’d like to tweak things up and down yourself, then you might consider something else. MeacoDry Arete One review: Should I buy it?
Automatic defrost - increases water extraction whilst saving energy when used in lower temperatures If you press the Smart Humidity mode button repeatedly, you can cycle between the available humidity targets, ranging from 40% to 70%rh, with a continuous option if you just want to keep dehumidifying, no matter what.
Other useful videos for this product
With a typical 2.45p per hour running cost, based on 15.2p/kWh, this unit is incredibly energy efficient and can help to reduce your bills. The MeacoDry ‘ABC’ can be practical remedy for moisture issues in your home such as damp, condensation, and can even be used as an alternative to your tumble dryer. Of course, it’s also quite expensive and for smaller rooms and spaces you can save some cash with a more compact 10-12L dehumidifier. But when you need serious drying power, you need a dehumidifier that’s up to the job – and here the Arete One has you covered. The Arete One is at its noisiest in clothes drying mode, where you’re looking at sound levels of over 50dB and power consumption of over 208W. What’s more, it’s not the most effective dehumidifier I’ve seen for actually drying your clothes; even after six hours some garments were still slightly damp to the touch. In the past we found the Ebac 2650eworked a little better, albeit over a longer 8 hour boost cycle. However, different washing loads and humidity levels make like-for-like comparisons impossible, and the Arete One is still a decent option – you can always leave it on at a lower humidity target or turn on continuous operation if you want it to finish drying out your laundry. The Arete One is also unusual for a compressor-based dehumidifier (one that uses refrigeration to cool and condense water in the air), in that it will work at temperatures of below 10°C. In fact, it’s designed to work at any temperature between 5°C and 25°C.
This is a compressor dehumidifier meaning you have low running costs, and when you see how quiet these dehumidifiers are you have a near perfect solution for dehumidifying in the home. Basically, if you have a larger house with large rooms and a damp problem, then this is the kind of dehumidifier you should look at if you want to deal with the issue. But is it up there the best? Free unlimited phone support with a UK dedicated claims line. We have a dedicated claims line and are here to help. What do you do if you already produce some of the quietest and most energy-efficiency dehumidifiers on the market? With Meaco’s new MeacoDry Arete One, the answer is to go even lower with power consumption and even quieter – and with some higher capacity options, too. Yes – it’s an excellent dehumidifier, especially for larger spaces. I don’t have the MeacoDry ABC or Inventor EVA II Pro 20L to hand to make direct comparisons but the Arete One is right up there with them in terms of performance and is either competitive or slightly better on noise and power consumption.The advantage of the size, drying power and capacity is that the Arete One can dehumidify larger areas than your average 10-12L dehumidifier. I’ve had it working on an upstairs landing and a large downstairs hallway, and in both cases, it did a solid job of controlling humidity and drying out areas affected by damp or mould, although in these sorts of environments you need to leave it running for longer periods to make an impact.
Energy Efficient costs just 2.7p/hour based on the UK average tariff of 15p/kWhEliminates Moisture – Ideal for damp and condensation It’s certainly an effective dehumidifier. In a small bedroom with damp and mould issues, I saw the humidity fall from 67% to 52% within a couple of hours, and I had to force the target down to 45% to keep the purifier busy. Automatic turn off – this setting prevents spillage when the water tank is full, protecting your home and property.In night mode I still found noise levels too high to sleep with it running in the same room, but it was fine running in a room downstairs or in another room, with only a barely perceptible low hum crossing walls or floors. MeacoDry Arete One review: What could be improved? We should point out that I took these sound readings using a smartphone app inside a home with wooden floors, and that sound levels will vary depending on your carpet, curtains and furnishings. Meaco’s own noise measurements, taken in a sealed chamber using calibrated microphones at 1m from all four sides, measured noise levels at between 38dB and 40dB for the 20L model and 40 and 42dB for the 25L model. Meaco’s existing 20L MeacoDry ABC dehumidifier produced a maximum 44dB(A) of noise at one metre and consumed roughly 244W. The Arete One is specified to top out at 40dB(A) and consume around 250W, although – as we’ll see later – measured consumption is actually much lower. Laundry mode – makes the machine run at full speed for 6 hours to help dry your clothes and then switch off to save energy
The new MeacoDry 'ABC' range offers the multi-award winning Meaco brand of dehumidifiers at an unbeatable entry-level price. Featuring the latest low-noise and energy-saving technology, the 10 litre MeacoDry 'ABC' is the quietest compressor dehumidifier from Meaco, making it the most effective and practical dehumidifying solution for the home.We know of customers who have tried all sorts of solutions to remove humidity in their property before finding the solution with the MeacoDry ‘ABC’ range. Giving you great value for money, it combines excellent performance with low energy costs and super-quiet operation, giving you the best of all worlds. Taking a tour of that interface for the first time reveals core controls that are brilliantly simple. Once you’ve tried it out then setting up the Meacodry ABC 10L Dehumidifier for different rooms is dead easy. Central to this is the humidistat button, which allows you to configure your preferred humidity removal level. It’s possible to set target relative humidity in increments of 5%, which is pretty precise really given the reasonably budget appeal of the machine. To take advantage of this great offer just simply add the warranty extension you want and we'll do the rest. As mentioned, the water tank stores 4.8L and simply slides in and out of the body of the unit. On even the heaviest day of testing I didn’t have to empty it more than once, although I’ve generally been working at room temperatures of around 22°C with humidity levels starting at around 62-67%. If you’re dehumidifying a seriously damp space or one that’s been flooded, then you may have to empty more often. The unit also supports continuous drainage, although you’ll need your own hose and a nearby drain or sink. The Meacodry ABC 10L Dehumidifier performs brilliantly without giving you a headache thanks to its noise levels, which remain below 40dB. The appliance is also cheap to run with the manufacturer highlighting it’ll use just 2.45 pence worth of electricity per hour, based on 15.2p/kWh.
Great Deal 
New Comment