Heater Element for Bosch Washing Machine

Product Information

Still nothing? The pump may be broken and need replacing or you could have an electrical fault. A technician can help with this. If the bolts have been removed and it's still not working it might be an issue with the installation. As well as looking unpleasant, if it builds up it can prevent detergent from being washed into the machine and water entering the drum.

Step 5. Unplug the electrical connectors attached to the control panel (ensure to take note of where each connector goes). Set the control panel aside. The good news is that you can easily replace it yourself or hire a tradesperson to do it for you – just make sure you buy a timer that is compatible with your washer make and model. Drain the water using either the hose provided (if there is one) or by unscrewing the cover on the pump impeller.There is also a tube attached to the switch. If this has come away from the switch the machine could also risk overfilling. Remove 2 Torx screws holding the bottom of the front panel in place (revealed now the lower panel has been removed). I chose to fit the temperature sensor into the heating element before fitting the element to the drum. This is done by pushing it in as far as the outer metal flange will allow. Warranties, which often cost but can last longer than a guarantee, may offer wider protection, such as in cases of accidental damage. The element plays an important role in keeping your appliance running, as it ensures the water is hot during the wash (if the water is not heated the machine may wash continuously and not finish a cycle).

Visit our guides to guarantees and warranties and your statutory rights to find out more about what to do in these situations and what your rights are. If it's not a problem with overloading, it could be one of these issues giving you a washing machine that won't spin:If your machine is out of warranty and guarantee and needs a repair, find a trusted appliance repairer near you using Which? Trusted Traders. More on this Step 9. Note the positioning of each electrical connector attached to the heating element, the disconnect each one. Overheating – If you have used your machine consecutively for the past five hours it might just be overheating. Give it a break and try again later.