Interior Brick Sealer & Dustproofer - Seal, Dustproof & Protect Interior Brick & Masonry (5 Litre)

Product Information

Importantly, although the product can be used throughout the year, try to avoid temperatures below 10°C. Only apply when realistically you would expect an external surface to dry. Avoid damp, cloudy days with no drying wind. Always remember that the surface needs to dry a few millimetres deep. Certainly, any moisture still present just below the surface will stop the product from penetrating correctly and reduce or neutralise its effectiveness. If spraying use only manual pump sprayer with large droplet nozzle. DO NOT MIST EU limit value for this product (cat.A/h): 30 g/l (2010) This product contains max. 1 g/l VOC. Dependent on the porosity of the surface 1 litre of product should cover approximately 4 to 6 m2 . STORAGE / SHELF LIFE Take some PVA, commonly known as Unibond®, and add about the equivalent of half a coffee mug to water and mix it in very thoroughly. The water should now look like milk. Our couriers do not deliver on a Saturday or Sunday (or bank holidays) other than by special additional arrangement.

Further Health and Safety information on this product is provided in the MSDS, copies of which are available from the Kingfi sher Technical Dept Tel. 01229 869100 or Fax 01229 869101. THE INFORMATION GIVEN IN THIS DATA SHEET RELATES ONLY TO THE SPECIFIC MATERIAL DESIGNATED AND MAY NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATION WITH ANY OTHER MATERIALS OR IN ANY PROCESS. SUCH INFORMATION IS TO THE BEST OF THE COMPANY’S KNOWLEDGE AND BELIEF, ACCURATE AND RELIABLE AS OF THE DATE INDICATED. HOWEVER NO WARRANTY, GUARANTEE OR REPRESENTATION IS MADE AS TO ITS ACCURACY, RELIABILITY OR COMPLETENESS. IT IS THE USER’S RESPONSIBILITY TO SATISFY THEMSELVES AS TO THE SUITABILITY AND APPLICATION OF SUCH INFORMATION FOR THEIR OWN USE. Disclaimer: “Unibond” is a registered trade mark, owned by Henkel, and is only used here as a product review. Thank you Sealers are made from toxic materials. Wear special protective gear when applying the sealer, and stay away from it while it is drying. Cover any plants around the surface and remove any animals from the vicinity. Once dried, the sealer should not pose any more health risks. I will post this on our blog, with my reply, and your details removed, to see if anyone else has any suggestions.One specification to look out for is the VOC level. VOC stands for volatile organic compounds, and they are incredibly bad for your health and are regulated by law. Look for lower VOC levels because they will be less toxic and have lower fumes. If the surface to be treated is merely dusty, then vacuum thoroughly until all traces of dust are removed and proceed directly to application. If there is ingrained dirt, wash with clean warm water and only resort to the use of soap detergents if gentle scrubbing with nylon bristle brush and warm water is ineff ective. Allow to dry out before proceeding to application. 2. Application This may sound like a no-brainer, but you must factor in how much sealer you need. Some jobs will require multiple containers of sealer, while others will only need half a gallon. We follow a detailed, rigorous process to create content that is helpful, factually correct and meets the highest standard of integrity. Our clear stone wall sealer, by contrast, is an advanced water-based fluoro-carbon which leaves no visible trace. It effectively repels liquids to protect the appearance of your stone surfaces without darkening. Liquids "bead up" on the surface and are not absorbed into the substrate, thus protecting your stone against staining. Suitable for interior sealing of:

Freezing and Thawing: Freezing and thawing can cause property damage to floors and walls, especially in locations prone to heavy winters. A sealer will prevent water from getting into your surfaces.

What should I use to seal an interior brick wall?

Stormdry only requires one coat, and we found that it was touch-dry after a few hours and water repellent after two days and largely water resistant after 28 days. In addition, our company offers several solutions if your house suffers from damp and mould, and if it has a scruffy external appearance, then we would suggest our exterior wall coating system which is guaranteed for 20 years. Some sealers can be used inside and outside, but others are only designed for one setting. Consider exactly where you use the sealer and select an option that matches accordingly. If you are using sealer outside, ensure it is safe for the environment. If you’re itching to see the walls and all that trim painted now, we feel you! We’re collecting paint quotes, and we’re in the final stages of choosing color. She’s looking like a real home, and it’s only looking up from here!

There is another option which is cheating basically, but would cost less and if done correctly, no one would know the difference unless they went up and touched the wall. Mildew and Mold: Mildew and mold are unsightly, smelly, and aggravating for allergies. Since a sealer will keep water out of the surface, mildew and mold are less likely to grow.We have adjusted the formula of this impregnating sealing product to improve application and sealing performance. Do not allow any sealer to simply dry on the surface, it should all have been absorbed into the treated surface or be removed (where present) after 20-30 minutes.