Abwan Integrated Circuit, Coolrunner Rev C for Jasper Trinity Corona Phat & Slim Cable Xbox360 Pulse IC

Product Information

Boot the console several times and ensure it boots consistently. If not, make sure your wiring is clean and neat and avoids noisy area. Run the wires near the X-Clamps for best results. Right now this tutorial is at dash 16747 (meaning the custom freeboot dash that you can update to once the console is exploited. An older dash might still needed to exploit the console in the first place. Refer to section 4 for this) which is the most recent dash.

Hey guys. Honestly I've been reading through threads here and elsewhere about how to mod my Trinity (as cheaply as possible - within reason). Your here because you found in the flow chart that your exploit method is the RGH method (dash higher than 7371, and console is a slim or a Xenon)When I power up the console, the green light on the Coolrunner does not light up (sometimes it lights up faintly, but rarely), the fans don't sound like they're glitching, the green light on the front of the console blinks constantly and it never boots Slim) Squirt Reloaded 2.X: remove R2 and connect STBY_CLK or remove 100 MHz and add 48 MHz oscillator

Highly Recommended: A case opening tool like this (you don't need it but if you have extra cash it helps) On chips with crystals, the optimal timing will depend on the crystal (how close it is to its rated frequency) Can use DemoN to do a dual NAND setup (about an extra 50-60 dollars) (DOESN'T WORK ON CORONA V2's/V4's)

Write a review

LibXenon (runs in xell) based apps/emulators: http://libxenon.org/index.php?PHPSESSID=ja3u7k1skvj561qjg9t2ifsst5&board=8.0 You can install XeXMenu to your hard drive by going to Console Settings > Storage, and copying it from your flash drive to the hard drive. Connect Ethernet and power on the console. The glitch chip should blink once or more times, and then the console should start into XeLL RELOADED. Can be used with the RGH1 or 2 wiring but isn't really needed on RGH1 setups. Highly recommended for RGH2 setups! Also note that if your on exactly 7371 there is a chance your CB was already patched which means it is not exploitable, and the only way to know for sure is to dump your NAND (this will be discussed after you have dumped your NAND)