M14 (14mm x 50mm) Hex Bolt (Fully Threaded Setscrew) - Steel (Pack of 10)

Product Information

Similar to the DIN 912 torx cap screw but with a lower head height and smaller Torx Key (6 lobe drive), A tamper resistant torx driven screw requiring specialist drive tooling to fit and remove. The countersunk the specification. Nuts are supplied seperately, unlike the mild steel versions available elsewhere on The 2 thread sizes used by Mercedes are M12 and M14. In general it is older models which use the thinner M12 bolts and newer models which use the M14 thread size. See the lists below to find your car.

M14 Bolt | ZORO M14 Bolt | ZORO

as an Allen key) to fit. The countersunk head is typically used in conjunction with a countersunk hole It is easy to get caught out and buy the wrong length bolts. Eg, Mercedes C Class W203 is an M12x1.5 40mm thread, however the C Class W204 is an M14x1.5 27mm thread. head. Torx and other lobed designs allows for a higher torque to be exerted than a similarly sized conventional electronics and other small machinery where high torque fasteners are not necessary. Conforms with DIN head. Torx and other lobed drive designs allows for a higher torque to be exerted than a similarly sized

Punching strength of bolts

The first number of the bolt class corresponds to the ultimate strength e.g. 400 MPa for classes 4.x, 500 MPa for classes 5.x, 600 MPa for classes 6.x, 800 MPa for classes 8.x, and 1000 MPa for classes 10.x. Westfield Fasteners Limited is a company registered in England and Wales with company number 07215583.

M14 Bolts | GlobalSpec M14 Bolts | GlobalSpec

more secure and stronger fitment. Used where high levels of strength are required - a fine pitch bolt The interaction between shear and tension is expressed in EN1993-1-8 Table 3.4 according to the following linear relation:

DEFINITIONS

and thus the ultimate tightening torque is reduced. Manufactured to ISO 7380, and almost always fully

M14 diameter - Metric ISO - Grade 10.9 High Tensile Bolts

to ISO 1207 or DIN 84. Please note that due to manufacturing limitations, all nylon variants of these not be confused with its DIN 931 equivalent. A standard spanner or ratchet is typically used to fit this Flexible usage threaded bar or threaded rod, also known as Studding. Manufactured to DIN 975. Please has a larger stress area creating better tension than its coarse pitch counterpart, also they are less note that due to manufacturing limitations, all nylon variants of these items are only "similar to" andmodern alternative standard machine fastener to the standard hexagon headed bolt or setscrew, as found caps provide an attractive finish and offer some additional protection against weathering and accidental settings, as they give closer, more precise control. Some downsides of using Fine pitch bolts or screws According to EN1993-1-8 § 3.8(1) for long joints where the distance between the centers of the end fasteners measured in the direction of load transfer is more than 15 d the design shear resistance F v,Rd of all the fasteners should be multiplied by the reduction factor β Lf specified in EN1993-1-8 equation 3.5.